Belkin F1UP0001 - Manual (Page 25)

23 22
Web Configuration Web Configuration
23
se
ct
io
n
2
1
3
4
5
6
7
8
9
IMPORTANT: Use the following encryption information only if your network
is encrypted. If it is not, leave the encryption mode (“WEP Mode” in the dialog
box illustrated below) set its default, “Disabled”.
This menu allows you to activate your Print Server’s encryption feature, which
is determined by your existing LAN encryption setting.
To set encryption for your Print Server choose the matching setting in the
dialog box above. The following briefly explains the various settings your
software makes available:
•
64-bit manually: Selecting this setting will allow you to enter your 64-bit
keys, if your wireless network uses 64-bit encryption (see dialog box on
the next page).
• 64-bit automatically: Selecting this setting will allow you to enter a pass
phrase to automatically generate encryption keys for your Print Server.
(Caution: This choice can generate new keys that will not function with
an existing network. If your network keys [in your router] are already set,
use manually instead.)
• 128-bit manually: Selecting this setting will allow you to enter your
128-bit keys, if your existing wireless network is encrypted using
128-bit encryption.
• 128-bit automatically: Selecting this setting will allow you to enter a
pass phrase and the Print Server will determine the keys automatically.
(Warning: Choosing “automatically” will generate new keys that may not
function with an existing network. If your network keys [in your router]
are already set, use “manually” instead.)
The Card cannot access the network because it uses a different network key
than the one configured on the wireless router.
Network Key = MyPassword
Network Key = MyPassword
Network Key = MyPassword
Network Key = WRONGPassword
Network Key =
WRONG
Password
Network Key =
MyPassword
Network Key =
MyPassword
Web Interface – Encryption
P74496uk_F1UP0001_man.indd 23 20/7/04 12:53:10 pm