Bryant 548J*14D - Manual (Page 33)

33
Step 12 — Install Accessories
Available accessories include:
Roof Curb (must be installed before unit)
Thru--base connection kit (must be installed before unit
is set on curb; see page 15)
Manual outside air damper
Two--Position motorized outside air damper (see page 9)
EconoMi$er IV (with control and integrated barometric
relief; see page 8)
EconoMi$er2 (without control/for external signal and
integrated barometric relief; see page 8)
Power Exhaust
Differential dry--bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
Electric Heaters (see page 16)
Single Point kits (see page 17)
Thermostat / Sensors (see pages 21--22)
CO
2
sensor (see pages 22--24)
Louvered hail guard
Phase monitor control
Refer to separate installation instructions for information
on installing these accessories.
Pre--Start and Start--Up
This completes the mechanical installation of the unit.
Refer to the unit’s Service Manual for detailed Pre--Start
and Start--up instructions.
548J
*14D