Bryant 548J*14D - Manual (Page 29)

29
Completing Installation of Return Air Smoke Sensor:
1. Unscrew the two screws holding the Return Air
Sensor detector plate. See Fig. 53. Save the screws.
2. Remove the Return Air Sensor and its detector plate.
3. Rotate the detector plate so the sensor is facing out-
wards and the sampling tube connection is on the bot-
tom. See Fig. 54.
4. Screw the sensor and detector plate into its operating
position using screws from Step 1. Make sure the
sampling tube connection is on the bottom and the ex-
haust tube is on the top. See Fig. 54.
5. Connect the flexible tube on the sampling inlet to the
sampling tube on the basepan.
Controller
Screws
Flexible
Exhaust
Tubes
Sampling Tube
C10331
Fig. 53 -- Return Air Detector Shipping Position
Sampling Tube
C10332
Fig. 54 -- Return Air Sensor Operating Position
Additional Application Data —
Refer to Catalog No. HKRNKA--1XA for discussions on
additional control features of these smoke detectors
including multiple unit coordination.
548J
*14D