Neff C47C62N3GB - Manual (Page 25)

25
2. Grip the door panel next to the hinges and pull it out of the
plug-in holders (not visible).
3. Lift the door panel slightly and remove it in the direction of the
hinges.
Removing the intermediate panel
Before removing, make a note of the position in which the
intermediate panel is fitted, so that you do not refit it the wrong
way round later.
1. Press the left and right-hand holders outwards.
2. Lift the intermediate panel slightly and take it out.
Cleaning
Clean the door panels with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
1. Insert the intermediate panel on the left and right into the
supports.
2. Push the intermediate panel downwards in the retainers.
Fitting the door panel
1. Insert the door panel on the left and right into the supports.
2. Press the door panel downwards into the plug-in holders.
3. Refit the appliance door.
Cleaning the rails
The rails can be removed for cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Detaching the rails
Note: Swing the front of the rail as far as possible (until you feel
resistance), because otherwise the appliance side panel may
become bent.
1. Carefully press the front of the rail upwards until it becomes
detached, and release it from the holder at the side (fig. A).
2. Detach the rail from the holder and remove it (fig. B).
3. Clean the rails with washing-up liquid and a sponge/brush
or
Clean the rails in the dishwasher.
Attaching the rail
1. Position the rail so that the indentations are facing upwards.
2. Hook the rail in at the back and push it towards the rear until
it engages (fig. C).
3. Hook the front of the rail onto the holder and press down until
it engages and is fixed level in place in the appliance once
more (fig. D).
Each set of rails only fits on one side.
% $
' &