Neff U16E74N3GB - Manual (Page 30)

30
Fitting the intermediate panel
Note: During installation, make sure that the lettering "top right"
is upside down at the bottom left.
1. Insert the intermediate panel towards the back as far as it will
go (fig. A).
2. Hook in the seal on both sides (fig. B).
3. Insert the retainer (fig. C).
4. Press down on the retainer until it locks into position (fig. D).
Fitting the door panel
1. Insert the door panel into the retainers at an angle towards
the rear (fig. E).
2. Press down door panel near the hinges until it locks into
place (fig. F).
3. Refit the appliance door.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1. Pull out and detach the hook-in rack at the front (Fig. A).
2. Clean the hook-in rack with washing-up liquid and a sponge
or brush.
3. After cleaning, refit the hook-in rack in the reverse order
(Fig. B).
Cleaning the telescopic shelves
You can unhook the telescopic shelves for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Removing the telescopic shelves
1. Hold the flat spring (Fig. A).
2. Move the telescopic shelf upwards at the front and unhook it
to the side.
3. Pull out the telescopic shelf at the back.
Cleaning the telescopic shelves
Clean the telescopic shelves with washing-up liquid and a
sponge or brush.
Hooking in the telescopic shelves
1. Insert the telescopic shelf at the rear as far as it will go.
2. Insert the telescopic shelf at the front from the top and push it
down until it engages (Fig. B).
3. Push telescopic shelves to the limit stop and close appliance
door.
% $
' &
) (
$ %
$ %