Nokia N76 - Manual (Page 132)

Settings
100
The available settings depend on the type of
enhancement. Select an enhancement and from the
following:
Default profile —Set the profile that you want activated
each time you connect a certain compatible enhancement
to your device. See ‘Profiles—set tones’, p. 47.
Automatic answer —Set if you want the device to answer
an incoming call automatically after 5 seconds. If the
ringing type is set to
Beep once or Silent , automatic
answer is disabled.
Lights —Set whether lights remain on, or are switched off
after the time-out. This setting is not available for all
enhancements.
If you are using a Text phone or a Loopset , you must
activate it on your device. To activate Text phone , select
Text phone > Use text phone > Yes . To activate the
loopset, select Loopset > Use loopset > Yes .
Security
To edit settings related to the security, press , and
select Tools > Settings > General > Security > Phone
and SIM card , Certificate management , or Security
module .
Phone and SIM card
PIN code request —When active, the code is requested
each time the device is switched on. Deactivating the
personal identification number (PIN) code request may not
be allowed by some SIM cards.
PIN code , PIN2 code , and Lock code —You can change the
lock code, PIN code, and PIN2 code. These codes can only
include the numbers from 0 to 9. If you forget any of these
codes, contact your service provider. See ‘Glossary of PIN
and lock codes’, p. 101.
Avoid using access codes similar to the emergency
numbers to prevent accidental dialing of the emergency
number.
Keypad autolock period —Select whether the keypad is
locked when your device has been idle for a certain period
of time.
Tip! To lock or unlock the keypad manually, press ,
then
Phone autolock period —To avoid unauthorized use, you
can set a time-out after which the device automatically
locks. A locked device cannot be used until the correct lock
code is entered. To turn off the autolock period, select
None .
See ‘Glossary of PIN and lock codes’, p. 101.