Nokia 6086 - Manual (Page 78)

M e s s a g i n g
45
Character support > Full — to select all characters in the messages to be sent as
viewed. If you select Reduced , characters with accents and other marks may be
converted to other characters. When writing a message, you can check how the
message will look to the recipient by previewing the message. See “Write and
send,” p. 38.
Reply via same center > Yes — to allow the recipient of your message to send you
a reply using your message center (network service)
Picture messages
The multimedia message settings affect the sending, receiving, and viewing of
multimedia messages and audio messages.
You may receive the configuration settings for multimedia messaging as a
configuration message. See “Configuration settings service,” p. 10. You can also
enter the settings manually. See “Configuration,” p. 72.
Select Menu > Messaging > Message settings > Picture messages and one of the
following options:
Delivery reports > On — to ask the network to send delivery reports about your
messages (network service)
Image size (picture msgs.) — to define the default image size used in
multimedia messages
Default slide timing — to define the default time between slides in
multimedia messages
Allow picture message reception > Yes or No — to receive or block the multimedia
message. If you select In home network , you cannot receive multimedia messages
when outside your home network. The default setting of the multimedia message
service is generally
In home network .
Incoming picture messages — to allow the reception of multimedia messages
automatically, manually after being prompted, or to decline the reception.
This setting is not shown if
Allow picture message reception is set to No .
Allow advertisements — to receive or decline advertisements. This setting is not
shown if Allow picture message reception is set to No or Incoming picture messages
is set to Reject .
Configuration settings > Configuration — only the configurations that support
multimedia messaging are shown. Select a service provider, Default , or t-zones for
multimedia messaging. Select Account and a multimedia messaging service account
contained in the active configuration settings.