Nokia N70 - Manual (Page 103)

Tools
102 Copyright © 2006 Nokia. All rights reserved.
Operator selection —Select Automatic to set the device
to search for and select one of the available networks, or
Manual to manually select the network from a list of
networks. If the connection to the manually selected
network is lost, the device sounds an error tone and asks
you to reselect a network. The selected network must have
a roaming agreement with your home network, that is, the
operator whose SIM card is in your device.
Glossary: A roaming agreement is an agreement
between two or more network service providers to
enable the users of one service provider to use the
services of other service providers.
Cell info display —Select On to set the device to indicate
when it is used in a cellular network based on
microcellular network (MCN) technology and to activate
cell info reception.
Enhancement settings
Indicators shown in the standby mode:
A headset is connected.
A loopset is connected.
The headset is unavailable, or a Bluetooth connection
to a headset is lost.
Select Headset , Loopset , or Bluetooth handsfree , and
the following options are available:
Default profile —to set the profile that you want activated
each time you connect a certain enhancement to your
device. See ‘Profiles—set tones’, p. 18.
Automatic answer —to set the device to answer an
incoming call automatically after 5 seconds. If the ringing
type is set to
Beep once or Silent , automatic answer is
disabled.
Voice commands
You can use voice commands to control your device. For
more information about the enhanced voice commands
supported by your device, see ‘Voice dialing’, p. 22.
To activate enhanced voice commands for starting
applications or profiles, you must open the
Voice com.
application and its Profiles folder. Press , and select
Tools > Voice com. > Profiles ; the device creates voice
tags for the applications and profiles. To use enhanced
voice commands, press and hold
and say a voice
command. The voice command is the name of the
application or profile displayed in the list.
To add more applications to the list, select Options > New
application . To add a second voice command that can be
used to start the application, scroll to it, select Options >
R1112_en.book Page 102 Monday, February 13, 2006 4:20 PM