Brother NX-400 - Manual (Page 65)

Useful Functions 59
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
6
Press to select .
To return to , press .
X The machine is now set for programmed
thread-cutting.
7
Press (OK key).
X The initial stitch screen appears again, and
appears in the lower-left corner of the
screen.
• When the sewing machine is turned off, the
programmed thread-cutting setting is
cancelled.
8
Position the fabric under the presser foot, and
then press
(start/stop button) once.
1 Start/stop button
X After reverse/reinforcement stitches are
sewn, the machine starts sewing.
9
After reaching the end of the stitching, press
(reverse/reinforcement stitch button)
once.
This step is not necessary if a stitch such as
those for sewing buttonholes and bar tacks is
selected where reinforcement stitches are
automatically sewn.
X After reverse/reinforcement stitches are
sewn, the sewing machine stops and cuts
the thread.
Memo
● Reverse/reinforcement stitches will not be
sewn and the thread will not automatically
be cut if the start/stop button is pressed at
the end of the stitching. Be sure to press the
reverse/reinforcement stitch button at the
end of the stitching.
1
The thread is cut here.