Toshiba Camileo Z100 - Manual (Page 10)

10
EN
Section 2
Getting Started
Loading the Battery
The battery comes pre-installed in the camcorder, however you
must remove the insulator on the battery before use.
1. Slide the safety latch and open the battery
cover.
2. Remove the battery from the camcorder and
pull the insulator off.
3. Insert the battery according to the correct
polarity marks ( + or -).
4. Close the battery cover firmly.
Note
• Different battery types and surrounding temperatures
may affect the battery performance.
• Never expose the battery to a heating equipment (e.g.,
microwave oven) and attempt to dispose of a battery by
burning or by throwing it into a fire. Heat can cause the
battery to explode and/or release caustic liquid, which
both may possibly cause serious injuries.
• Turn the power off and stop using the battery if you
observe the condition of excessive heat from the battery.
Charge your battery
For a better performance, please charge the battery fully
before its first use. You must use the supplied AC charger or
the USB cable. The camcorder must be turned OFF. A blinking
light indicates active charging and a solid light indicates that
charging is complete. In adapter charging mode, the full
charging time is about 4- 5 hours and the light will turn off
automatically after 3~5 minutes. (Actual charging time may vary.
It depends on the battery condition.)
Note
• In PC USB charging mode, the camcorder is
charged by less electric current. A longer charging
time (12~12.5 hrs) is required.
• Never charge the battery with a way other than
as instructed. Otherwise, a fire or any explosion
resulting in any serious injury is possible.
• Use the supplied AC adapter only with the indicated
power supply voltage.
• Use any other power supply voltage might cause
electric shock.
• Be sure that the power outlet that the adapter you plug in is easily accessible. When you
need to disconnect power from the device, be sure to unplug the power cord from the
electrical outlet.
REMOVE