Toshiba AT300SE-B - Manual (Page 33)

1. Plug the Micro USB connector of the USB cable into the Micro USB
port on this tablet.
Figure 4-2 Connecting an USB cable
1
2
1. Micro USB port 2. Micro USB connector
2. Plug the other end of the USB cable into the USB port on the
computer.
Depending on your settings, your tablet will be recognized as a removable
MTP (Media Transfer Protocol) device or PTP (Picture Transfer Protocol)
device allowing you to access its contents from a computer.
If your computer does not support MTP, try using PTP for connection.
To remove this tablet from a computer:
1.
Make sure all file operations are finished.
2. Unplug the tablet from your computer.
Make sure the connector is properly aligned with the socket. Do not try to
force the connection, doing so can damage the connecting pins.
Factory Reset
The tablet provides you with the function to reset it. Before executing the
reset, you need to backup the system settings, application settings, user
installed applications and data in the internal storage.
To perform the factory data reset, please follow the steps below:
1.
Tap All Apps -> Settings -> Backup & reset -> Factory data reset -
> Reset tablet -> Erase everything.
2. The factory data reset will be done.
Please note that the following data will be erased:
System settings and application settings
User installed applications
Internal storage files, such as music or photos
Data in the removable media will not be erased.
AT300SE series
User's Manual 4-8