Pioneer DDJ-SB - Manual (Page 9)

En 9
Connections
and
part
names
! When the [f] button is pressed during cue sampling, play-
back continues from that point.
[SHIFT] + press:
Loads the previous track in the library. (Previous Track)
! If the current playback position is not the beginning of a track,
the track returns to the beginning.
c SYNC (OFF) button
Press:
The tempo (pitch) of tracks on adjacent decks can be synchronized
automatically.
[SHIFT] + press:
Cancels the sync mode.
d SHIFT button
When another button is pressed while pressing the [SHIFT] button, a
different function is called out.
Mixer section
0
LOW
HEADPHONES MIX
MASTER CUE
HEADPHONES LEVEL
MAX MIN
MASTER LEVEL
CUE
FILTER FADE
CH FADER START
PANEL
BACK
MAX MIN
FILTER
MAX MIN
HPF LPF
MID
MAX MIN
HI
1
LOW
CUE
CH FADER START
MAX MIN
FILTER
MAX MIN
HPF LPF
MID
MAX MIN
HI
2
ON
1
2
3
4
1
2
3
4
5
6
7
8
9
1 EQ (HI, MID, LOW) controls
Boosts or cuts frequencies for the different channels.
2 FILTER control
Applies the filter effect for the respective channel.
The original sound is output when the control is at the center
position.
Turn counterclockwise: Gradually decreases the low-pass filter’s
cutoff frequency.
Turn clockwise: Gradually increases the high-pass filter’s cutoff
frequency.
3 Headphones CUE button
Press:
The sound of channels for which the headphones [CUE] button is
pressed is output to the headphones.
! When the headphones [CUE] button is pressed again, monitoring
is canceled.
4 Channel fader
Move:
Adjusts the level of audio signals output in each channel.
[SHIFT] + move:
Serato DJ
Use the channel fader start function.
5 FILTER FADE button
Turns the filter fade function on and off.
= Using the filter fade function (p.16)
6 Crossfader
Switches between the audio output of the left and right decks.
7 MASTER LEVEL control
Adjusts the master sound level output.
8 HEADPHONES MIX control
Adjusts the balance of the monitor volume between the sound of the
channels for which the headphones [CUE] button is pressed and the
sound of the master channel.
9 HEADPHONES LEVEL control
Adjusts the sound level output from the headphones.
Effect section
This section is used to control the two effect units (FX1 and FX2).
Controls and buttons to operate the FX1 unit are located on the left side
of the controller, those to operate the FX2 unit are located on the right
side of the controller.
FX1
1
LEVEL
SELECT SELECT SELECT
BEATS
2 3
1 2 3 4
1 Effect 1 button
Turns the effect on/off.
[SHIFT] + press:
Switches the effect type.
2 Effect 2 button
Turns the effect on/off.
[SHIFT] + press:
Switches the effect type.
3 Effect 3 button
Turns the effect on/off.
[SHIFT] + press:
Switches the effect type.
4 Effect level controls
These adjust the effects’ parameters.
= Using effects (p.15)
[SHIFT] + press:
Adjusts the effect time.