Pioneer BCS-FS500 - Manual (Page 43)

43
Notes:
• You cannot change the video resolution at the HDMI IN 1/2 mode.
Change the video resolution of the connected component.
• The setting of the sound mode is not available when Dolby Digital Plus,
Dolby TrueHD and DTS-HD are played at HDMI IN 1/2 mode.
• If the video output signal is abnormal when your personal computer is
connected to HDMI IN 1/2 jack, change the resolution of your personal
computer to 576p, 720p, 1080i or 1080p.
1 Connect the optical or coaxial output jack
of your component into the OPTICAL or
COAXIAL (DIGITAL AUDIO IN) jack on the
rear panel of this unit.
-
2 Turn the power on: STANDBY/ON
3 Select the [OPTICAL] or [COAXIAL] option: INPUT
4 Turn down the volume: VOL (+/-)
5 Turn your component on: -
6 Adjust the volume: VOL (+/-)
You can enjoy the sound of your component with the digital
optical or coaxial output jack from the speakers of the system.
ON REMOTE
Using DIGITAL AUDIO IN jacks
To the digital optical output jack of your component
To the digital coaxial output jack of your component
or
1 Connect the HDMI OUT jack of your
component into the HDMI IN 1 or 2 jack on
the rear panel of this unit.
-
2 Turn the power on: STANDBY/ON
3 Select the [HDMI IN 1] or [HDMI IN 2] option: INPUT
4 Turn down the volume of this unit: VOL (+/-)
5 Turn your component on: -
6 Adjust the volume of this unit: VOL (+/-)
You can enjoy the pictures and sound of your component with the HDMI
OUT jack.
ON REMOTE
Using HDMI IN jacks
To the HDMI OUT jack of your component
(set-top box, digital satellite receiver, video game machine, etc.)