Pioneer DVR-530H-S - Manual (Page 57)

Recording 06
57
En
Recording from an external
component
You can record from an external component, such as a
camcorder or VCR, connected to one of the recorder’s
external inputs.
1 Make sure that the component you want to
record from is connected properly to the DVD
recorder.
See Chapter 2 ( Connecting up ) for connection options.
2 Press INPUT SELECT repeatedly to select one of
the external inputs to record from.
There are three analog inputs and a DV digital input. The
current input is shown on-screen and in the front panel
display:
• AV2/L1 – Input 1 1
• L2 – Input 2 (front panel)
• L3 – Input 3
• DV – DV input (front panel)
Check that the Audio In settings for External Audio ,
Bilingual Recording and DV Input are as you want them
(see Audio In Settings on page 102).
• If the aspect ratio is distorted (squashed or
stretched), adjust on the source component or your
TV before recording.
3 Set up the recorder.
• Use REC MODE to set the recording quality. See
Setting the picture quality/recording time on page 51
for detailed information.
• Press HDD to record to the hard disk drive, or DVD to
record to a DVD.
4 Press ì REC when you’re ready to start
recording.
• The recorder will only start recording from the DV IN
jack if there is a valid signal. Recording will also
pause if the signal is interrupted during recording.
• If your source is copy-protected using CopyGuard,
you will not be able to record it. See Restrictions on
video recording on page 50 for more details.
Note
1.This cannot be selected if AV2/L1 In is set to Decoder (see AV2/L1 In on page 102).
VR mode Video mode HDD
INPUT
SELECT
HDD DVD
REC REC MODE
ì
DVR-530H_EU.book 57 ページ ２００５年２月１４日 月曜日 午後２時２０分