Pioneer DVR-530H-S - Manual (Page 55)

Recording 06
55
En
5 Use the / to move the cursor to the
recording end time on the grid.
As you move the cursor around the grid, an arrow
stretches from the start time to the current cursor
position, representing the length of the recording. A
recording of up to six hours can be set.
6 Press ENTER to set the end time.
7 Select ‘Yes’ to set the timer recording and exit, or
‘No’ to go back to the timer recording screen.
• You can check the timer recording details you just set
from the Schedule Area in GUIDE Plus+; see The
Schedule Area on page 43).
Extending a timer recording in progress
You can extend a timer recording beyond the
programmed end time in two different ways. This can be
useful if a broadcast program overruns, for example.
Moving the end time by 30-minute blocks
1 During timer recording, press and hold ì REC for
three seconds.
The timer indicator disappears from the front panel
display.
2 Press ì REC repeatedly to extend recording in 30
minute increments.
Canceling and stopping a timer recording in
progress
After a timer recording has started, you can cancel the
program (but continue recording), or stop recording
completely if you need to.
1 During timer recording, press and hold ì REC for
three seconds.
Only the program is canceled (the timer indicator
disappears); recording continues so that you can
manually stop recording whenever you like.
2 When you want to stop recording completely,
press STOP REC.
Tip
• You can also stop a timer recording immediately by
pressing STOP REC then selecting Yes to confirm.
Preventing use of the recorder before a
timer recording (child lock)
You can make all the front panel and remote control
buttons inoperative using the child lock feature. This is
useful when you set a timer recording and want to make
sure that the timer settings are not changed before
recording has finished.
1 If the recorder is on, switch it into standby.
2 Press and hold STOP on the front panel for
three seconds to lock the controls.
The front panel display briefly shows LOCK . If any buttons
are pressed on the remote or front panel, LOCK is briefly
displayed again.
• To unlock the recorder, press and hold STOP on
the front panel for three seconds until the display
shows
UNLOCK .
• To cancel a timer recording when the recorder is
locked, first unlock the recorder (see above), then
press and hold
ì REC for three seconds.
Easy Timer
Pr 7
SAT
1/01 11:45
HDD CHANNEL +/– HDD/DVD SP REC MODE
11:00 12:00 13:00 14:00 15:00 16:00 17:00
– 13:45
1/01
2/01
3/01
Recording start time
Recording end time
HOME
MENU
ENTER
REC STOP REC TIMER REC
ì
REC STOP REC
ì
DVR-530H_EU.book 55 ページ ２００５年２月１４日 月曜日 午後２時２０分