Pioneer HTP-SB300 - Manual (Page 26)

Controlling the rest of your system 05
26
En
Chapter 5
Controlling the rest of your
system
Setting the remote to control
other components
Most components can be assigned to one of
the
or INPUT SELECT buttons using
the component’s manufacturer preset code
stored in the remote.
However, please note that there are cases
where only certain functions may be
controllable after assigning the proper preset
code, or the codes for the manufacturer in the
remote control will not work for the model that
you are using.
Note
• You can cancel or exit any of the steps by
pressing .
• After one minute of inactivity, the remote
automatically exits the operation.
Select preset codes for TVs
1 While pressing the button,
press and hold the ‘1’ button for three
seconds.
2 Press the button.
3 Use the number buttons to enter the
preset code.
You can find the preset codes on page 30.
If the correct code has been input the power of
the TV being input will turn on or off.
The power of the TV being input will only turn
on or off if that TV is able to be turned on
directly by remote control.
4 Repeat steps 2 through 3 to try a different
code.
5 When you’re done, press .
SYSTEM SYSTEM
TV CONTROL
HDMI1 HDMI2
OPTICAL COAXIAL
STANDARD
AUTO/ STEREO/
ADV SURR
CH
VOL
SOURCE INPUT
INPUT
INPUT
TV CODE
DISPLAY
CH
CH
ENTER
MUTE
HTP-SB300_SVYXCN_En.book 26 ページ ２００９年１０月２３日 金曜日 午後１時５８分