Pioneer HTP-SB300 - Manual (Page 12)

Connecting up 02
12
En
Important
• Compared to existing digital audio
transmission formats (optical and coaxial),
HDMI format digital audio transmissions
requires a longer time to be recognized.
Due to this, interruption in the audio may
occur when switching between formats or
beginning playback.
Additionally, turning on/off the component
connected to this unit’s HDMI OUT
terminal or disconnecting/connecting the
HDMI cable may cause noise or
interrupted audio.
Digital audio cables
Commercially available coaxial digital audio
cables or optical cables should be used to
connect digital components to this system.
1
Coaxial digital audio cable
Optical cable
Connect your TV (For TV audio)
This will allow you to play the sound from the
TV’s built-in tuner.
• Televisions without digital audio output
connectors cannot be connected to this
unit.
• Connect the optical digital output on your
TV to the OPTICAL AUDIO IN on this system.
2
Use an optical cable.
• If your TV has a coaxial digital output, you
can also use a coaxial digital audio cable
for the connection.
Note
1 • When connecting optical cables, be careful when inserting the plug not to damage the shutter protecting the optical
socket.
• When storing optical cable, coil loosely. The cable may be damaged if bent around sharp corners.
• You can also use a standard RCA video cable for coaxial digital connections.
2 When connecting this system to a playback component through a television set, in some cases sound may not be
produced from the televisions digital audio output. In this case, connect this system directly to the playback component.
DIGITAL OUT
OPTICAL COAXIAL
OPTICAL COAXIAL
OUT
AUDIO IN
TV
Select one
HTP-SB300_SVYXCN_En.book 12 ページ ２００９年１０月２３日 金曜日 午後１時５８分