Putting the batteries in the remote control, Using the remote control, Controls and displays 03 – Pioneer HTP-SB300 User Manual
Page 19
Controls and displays
03
19
En
English
Deutsch
Italiano
Español
Pyccкий
Français
Nederlands
Putting the batteries in the remote
control
Caution
Incorrect use of batteries can result in hazards
such as leakage and bursting. Please observe
the following:
• Don’t mix new and old batteries together.
• Don’t use different kinds of battery
together — although they may look similar,
different batteries may have different
voltages.
• Make sure that the plus and minus ends of
each battery match the indications in the
battery compartment.
• Remove batteries from equipment that
isn’t going to be used for a month or more.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction’s rules
that apply in your country/area.
• Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.
Using the remote control
Please keep in mind the following when using
the remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
• Replace the batteries when you notice a
fall off in the operating range of the remote.
• Use within the operating range in front of
the remote control sensor on the unit, as
shown.
30°
30°
7 m
HTP-SB300_SVYXCN_En.book 19 ページ 2009年10月23日 金曜日 午後1時58分