Pioneer VSA-AX10Ai-S - Manual (Page 82)

Other connections 09
82
En
Use a commercially-available cable to connect the RS-
232C jack on your computer to the 9-pin RS-232C jack on
this amplifier. See the documentation provided with the
Advanced MCACC application for more information.
Advanced MCACC output using your PC
Before continuing, make sure you have completed steps
1–6 in
Using Professional Acoustic Calibration EQ on
page 58.
Note
• Transmission data is erased when the amplifier is
turned off.
1 Select ‘PC Output’ and press ENTER.
When the amplifier is ready for transmission, Operate a
PC shows on the OSD.
• If PC Output isn’t displayed, the amplifier probably
doesn’t have any transmission data. Make sure you
have completed steps 1–6 in
Using Professional
Acoustic Calibration EQ on page 58.
2 Start the MCACC application on your computer.
Follow the instructions provided with the application. It
will take about ten seconds for the transmission to
complete, then you will be able to analyze the output on
your computer. Since the data will be cleared from the
amplifier when you restart reverb measurement or turn
off the amplifier, you might want to save the information
on your PC after measurement.
3 When you’re finished, select ‘Return’ on the on-
screen display.
You’ll be taken to the Advanced EQ Setup. Depending on
the results, you may want to continue with the Advanced
EQ setup (see
Setting Professional Acoustic Calibration
EQ according to your room characteristics on page 57 for
more on this). You can also simply press
Return again to
exit the Professional Acoustic Calibration EQ setup.
RS-232C
PC
2.4. Acoustic Cal EQ Pro.
Manual Pro.
[ Reverb Measurement ]
[ Reverb View ] _
[ PC Output ]
[ Advanced EQ Setup ]
[Return]
2.4. Acoustic Cal EQ Pro.
Operate a PC
[
Return ]