Pioneer VSA-AX10Ai-S - Manual (Page 50)

Listening to your system 05
50
En
Listening to dual mono soundtracks
You can specify how dual mono encoded Dolby Digital
soundtracks should be played. Dual mono is not widely
used, but is sometimes necessary when two languages
need to be sent to separate channels.
1 Press OPTION repeatedly to select DUAL MONO.
The remote control menu for this step is shown below
(see note at the start of this chapter if you need help).
2 Use the (OPTION) +/– buttons to change the
setting.
• CH1 – Only channel 1 is played
• CH2 – Only channel 2 is played
• CH1/CH2 – Both channels are played through the
front speakers
Note
• On the CH1 and CH2 settings the sound comes only
from the center speaker (or from the front speakers if
NO was selected for the center speaker setting).
• This setting works only with dual mono encoded
Dolby Digital and DTS soundtracks.
• When listening to a dual mono source, the L and R
indicators on the front panel flash. The channel you
select will light in the display.
AMPLIFIER 2/3
AMPLIFIER
TV
CONT
MIDNIGHT DIGITAL NR
TONE LOUDNESS
OPTION + –
CH LEVEL + –
PHONES SP SYSTEM
A/B
SIGNAL
SELECT VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIO L R
MIDNIGHT LOUDNESS OPTION TONE DIGITAL NR INPUT ATT SELECT
CH LEVEL ACOUSTIC
CAL.