Dimming the display, Switching the speaker impedance, Using other functions 08 – Pioneer VSA-AX10Ai-S User Manual
Page 72: Cd-r/ tape1/md

Using other functions
08
72
En
Dimming the display
You can choose between four brightness for the front
panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
•
From the remote control amplifier menu, press
DISPLAY DIMMER repeatedly to change the
brightness of the front panel display.
You may need to press
on the Home menu (
)
first before reaching the amplifier menu screen shown
below (use the
/ (cursor left/right) soft keys to go to
the previous/next menu screen).
Switching the speaker impedance
• Default setting:
Speaker 6Ω
Ω
Ω
Ω
You can use speakers with a nominal impedance
between 4–16Ω but if you are using speakers with an
impedance of less than 6Ω, you must change the
impedance setting below.
•
With the amplifier in standby, press STANDBY/
ON while holding down the OPTION – button.
Each time you do this, you switch between the
impedance settings:
•
Speaker 4Ω
Ω
Ω
Ω – Use this setting if your speakers are
rated lower than 6Ω (down to 4Ω).
•
Speaker 6Ω
Ω
Ω
Ω – Use this setting if your speakers are
rated 6Ω–16Ω.
Note
• If you select
Speaker 4Ω
Ω
Ω
Ω above, the Stream Direct
setting is fixed at
SD:1 NORMAL (see Using the
Stream Direct mode on page 43).
AMPLIFIER
AMPLIFIER
3/3
SB CH
MODE
INPUT
STATUS
INPUT
ATT
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
RECEIVER
TV
CONT
STANDBY/ON
OFF
ON
STANDBY
DVD/LD
TV/DVD
SAT
VIDEO
VIDEO
AUDIO
DVR/VCR1
VCR2
VCR3
CD
TUNER
P
CD-R/
TAPE1/MD
INPUT SELECTOR
PHONES
SP SYSTEM
A/B
SIGNAL
SELECT
VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO
VIDEO
VIDEO INPUT
AUDIO
L
R
MIDNIGHT
LOUDNESS
OPTION
TONE
DIGITAL NR
INPUT ATT
SELECT
CH LEVEL
ACOUSTIC
CAL.