Pioneer VSA-AX10Ai-S - Manual (Page 46)

Listening to your system 05
46
En
Using the surround back channel
• Default setting: SB CH ON
You can have the amplifier automatically use 6.1 or 7.1
decoding for 6.1 encoded sources (for example, Dolby
Digital EX or DTS-ES), or you can choose to always use
6.1 or 7.1 decoding with other sources (for example, 5.1
encoded material). With 5.1 encoded sources, a
surround back channel will be generated, but the
material may sound better in the 5.1 format for which it
was originally encoded, in which case you can simply
switch the surround back channel off. The table below
indicates when you will hear the surround back channel
when playing various kinds of sources. (
ì =Sound plays
through surround back channel speaker(s); = 7 CH
SURROUND shows in the display; = Home THX is
selected and two surround back speakers are connected)
• Press SB CH MODE repeatedly to cycle through
the surround back channel options.
The remote control menu for this step is shown below
(see note at the start of this chapter if you need help).
Each press changes the setting as follows (see the table
above for an explanation of each):
• SB CH AUTO – Automatically switches to 6.1 or 7.1
decoding for 6.1 encoded sources (for example,
Dolby Digital EX or DTS-ES)
• SB CH ON – 6.1 or 7.1 encoding is always used (for
example, on 5.1 encoded material)
• SB CH OFF – Surround back channel is switched off
Note
• You will only hear the surround back channel when
you’ve selected SP A as the speaker setting (see
Switching the speaker system on page 75). Changing
the speaker system may automatically change this
setting (see notes below).
• If the surround back speaker is set to NO in Speaker
Systems on page 52, or you have selected SP A+B
as the speaker setting, you can only use the virtual
surround back effect (see next page).
• You can’t select the surround back channel setting (it
is automatically switched off) when you’ve selected
SP B as the speaker setting or when Bi-Surround is
selected in
Speaker Systems on page 52.
• You can’t use the surround back channel setting
when Stream Direct is on or when the STEREO mode
is selected.
• When the THX mode is selected, you can’t select SB
CH OFF if you’re listening to DVD-Audio or SACD.
Type of source
SB CH
mode
Standard / THX
Advanced
surround
Multichannel
sources
Stereo sources
2 Pro Logic II x 2 Pro Logic NEO:6
Dolby Digital EX/DTS-ES encoded
multichannel source with 6.1ch
surround ON м м
AUTO м м
Dolby Digital/DTS encoded
multichannel source ON м м
AUTO м
м
Dolby Digital/DTS encoded stereo
source; other digital stereo source ON м м м м
AUTO м м м
Analog 2-channel (stereo) source ON м м м м
AUTO м м м
AMPLIFIER 3/3
SB CH
MODE
INPUT
STATUS
INPUT
ATT
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
AMPLIFIER
TV
CONT
PHONES SP SYSTEM
A/B
SIGNAL
SELECT VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIO L R
MIDNIGHT LOUDNESS OPTION TONE DIGITAL NR INPUT ATT SELECT
CH LEVEL ACOUSTIC
CAL.