Mixing avg-vdp1 beep and audio sound, Correcting distorted sound, Setting the tv signal – Pioneer AVH-P6000DVD User Manual
Page 97: Initial setup

! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
% Touch TEL/GUIDE on the initial menu to
select any of the muting, attenuation or
off.
Touch
TEL/GUIDE until the desired setting ap-
pears in the display.
! MUTE – Muting
! ATT -20dB – Attenuation (ATT -20dB has a
stronger effect than
ATT -10dB)
! ATT -10dB – Attenuation
! OFF – Turn the sound muting/attenuation
off
Notes
! The sound is muted or attenuated, MUTE or
ATT are displayed and no audio adjustment is
possible.
! Operation returns to normal when the phone
connection or the voice guidance is ended.
Mixing AVG-VDP1 beep and
audio sound
When connecting the AVG-VDP1 to this unit, a
beep sound is occasionally outputted from the
AVG-VDP1. To ensure the quality audio sound
from this unit, set this function to
GUIDE to
properly mix the beep sound and the audio
sound.
! You can operate this function only when a
Pioneer Vehicle Dynamics Processor (AVG-
VDP1) is connected to this unit.
! When the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you
cannot use this function.
! We recommend that you select GUIDE to
ensure quality sound.
% Touch VDP MIX on the initial menu to
switch the mixing of AVG-VDP1 beep.
Touching
VDP MIX switches the mixing set-
tings between
ALL (mixing all the time) and
GUIDE (mixing when a beep sound is out-
putted).
Correcting distorted sound
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to
LOW. Normally, leave the set-
ting at
HIGH to ensure quality sound.
! Only when the multi-channel processor
(e.g., DEQ-P6600) is connected to this unit,
you can operate this function.
% Touch D. ATT on the initial menu to
switch the digital attenuator setting.
Touching
D. ATT switches the digital attenua-
tor settings in the following order:
HIGH
—LOW
Setting the TV signal
When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
! This function is initially set to AUTO so that
this unit automatically adjusts the TV signal
setting.
% Touch TV SIG on the initial menu to se-
lect an appropriate TV signal.
Touching
TV SIG switches TV signal settings
in the following order:
AUTO
—PAL—SECAM
Initial Setup
En
97
Section
20
Initial
Setup