Initial setup adjusting initial settings, Switching the auxiliary setting, Setting the rear output and subwoofer – Pioneer AVH-P6000DVD User Manual

Page 95: Controller, Setting the rear, Adjusting initial settings, Setting the rear output and subwoofer controller, Initial setup

Adjusting initial settings

Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.

1 Source icon

Shows which source has been selected.

2 Function display

Shows the function names.

Touch the source icon and then touch

OFF to turn this unit off.

# When the source icon is not displayed, you
can display it by touching the screen.

Touch AUDIO MENU and then touch

INITIAL to display the function names.
The function names are displayed and oper-
able ones are highlighted.

# To go to the next group of function names,
touch

NEXT.

# To return to the previous group of function
names, touch

PREV.

# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 102.

% Touch AUX1/AUX2 on the initial menu
to turn each auxiliary setting on.

# To turn auxiliary setting off, touch AUX1/
AUX2 again.

Setting the rear output and
subwoofer controller

This unit

’s rear output (rear speaker leads out-

put) can be used for full-range speaker (

FULL)

or subwoofer (

SUB. W) connection. If you

switch the rear output setting to

SUB. W, you

can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (

FULL). When rear output is

connected to full range speakers (when

FULL

is selected), you can connect the RCA sub-
woofer output to a subwoofer. In this case, you
can select whether to use the subwoofer con-
troller

’s (low pass filter, phase) built-in SUB.W

or the auxiliary

FULL.

! When the multi-channel processor (e.g.,

DEQ-P6600) is connected to this unit, you
cannot operate this function.

Touch REAR SP on the initial menu.

Touch c or d on the REAR SPEAKER to

switch the rear output setting.
Touch c to select full-range speaker and FULL
appears in the display. Touch d to select sub-
woofer and

SUB. W appears in the display.

# When no subwoofer is connected to the rear
output, select

FULL (full-range speaker).

Initial Setup

Section

Initial

Setup