Pioneer AVH-P6000DVD - Manual (Page 79)

! MUSIC – The Music mode suitable for
music playback
! MATRIX – The Matrix mode for when FM
radio reception is weak
! OFF – Turn Dolby Pro Logic II off
! ADJUST – Adjust the Music mode
# You can operate ADJUST only when MUSIC
has been selected.
Adjusting the Music mode
You can adjust the Music mode with the fol-
lowing three controls.
! Panorama (PANORAMA) extends the front
stereo image to include the surround
speakers for an exciting
“wraparound” ef-
fect.
! Dimension (DIMENSION) allows you to
gradually adjust the sound field either to-
wards the front or the rear.
! Center Width Control (CENTER WIDTH) al-
lows center-channel sounds to be posi-
tioned between the center speaker and the
left/right speakers. It improves the left-cen-
ter-right stage presentation for both the dri-
ver and the front passenger.
1 Touch DOLBY PRO LOGIC II on the DSP
function menu.
2 Touch MUSIC and then touch ADJUST.
# You can operate ADJUST only when MUSIC
has been selected.
3 Touch a or b to select PANORAMA (pa-
norama).
Each time you touch a or b selects the item
in the following order:
PANORAMA (panorama)
—DIMENSION (di-
mension)
—CENTER WIDTH (center width)
4 Touch c to turn the panorama control
on.
# To turn the panorama control off, touch d.
5 Touch b to select DIMENSION and then
touch c or d to adjust front/surround
speaker balance.
Each time you touch c or d it moves the
sound towards the front or the surrounds.
+3 to
–3 is displayed as the front/surround
speaker balance moves from front to sur-
rounds.
6 Touch b to select CENTER WIDTH and
then touch c or d to adjust the center
image.
Each time you touch c or d it gradually
spreads the center channel sound into the
front left and right speakers over a range
0 to
7.
3 is the default and it
’s recommended for
most recordings. 0 places all center sound in
the center speaker. 7 places all center sound
equally in the left/right speakers.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to
LARGE (large)
if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select
SMALL (small).
! When DIGITAL DIRECT is on, you cannot
select SPEAKER SETTING. First turn the
DIGITAL DIRECT off, referring to Using the
direct control on the previous page.
! Low frequency range is not output if the
subwoofer is set to OFF and the front and
rear speakers set to SMALL or OFF.
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LARGE if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
Digital Signal Processor
En
79
Section
17
Digital
Signal
Proces
sor