Pioneer AVH-P6000DVD - Manual (Page 87)

# Press SOURCE to turn the source on if this
unit is turned off.
4 Select the position for the seat on
which the microphone is placed.
Refer to Using the position selector on page
76.
# If no position is selected before you start auto
TA and EQ,
FRONT-L is selected automatically.
5 Press SOURCE and hold until the unit
turns off.
6 Touch and hold EQ to enter the auto TA
and EQ measurement mode.
7 Plug the microphone into the micro-
phone input jack on the multi-channel pro-
cessor.
AUTO TA&EQ microphone
For details concerning operation, refer to the
multi-channel processor
’s operation manual.
8 Touch START to start the auto TA and
EQ.
9 Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completed in about nine minutes.
# To stop auto TA and EQ, touch STOP.
# To cancel auto TA and EQ part way through,
touch
BACK or ESC.
10 When auto TA and EQ is completed,
Complete is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Under-
standing auto TA and EQ error messages on
page 107.)
11 Touch ESC to cancel the auto TA and EQ
mode.
12 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or mal-
function.
Digital Signal Processor
En
87
Section
17
Digital
Signal
Proces
sor