Pioneer FH-P4000R - Manual (Page 56)

En 56
13
Section
Additional Information
Message Cause Action
CD ERR-11, 12,
17, 30 Dirty disc Clean disc.
CD ERR-11, 12,
17, 30 Scratched disc Replace disc.
CD ERR-14 Blank disc Check the disc.
CD ERR-10, 11,
12, 14, 17, 30,
A0 Electrical or
mechanical Turn the ignition
ON and OFF, or
switch to a
different source,
then back to the
CD player.
CD ERR-44 All tracks are
skip tracks Replace disc.
HEAT CD player over-
heated Turn off the CD
player until the
CD player cools
down.
• Do not attach labels, write on or apply chemi-
cals to the surface of the discs.
• To clean dirt from a CD, wipe the disc with a
soft cloth outward from the center of the disc.
• If the heater is used in cold weather, moisture
may form on components inside the CD
player. Condensation may cause the CD
player to not operate properly. If you think that
condensation is a problem turn off the CD
player for an hour or so to allow the CD player
to dry out and wipe any damp discs with a soft
cloth to remove the moisture.
• Road shocks may interrupt CD playback.
CD-R discs
• CD-R (CD-Recordable) discs recorded on
CD-R units other than a music CD recorder
may not play properly on this CD player.
• Music CD-R discs, even recorded on a music
CD recorder, may not play properly on this CD
player due to differing disc characteristics,
scratches or dirt on the disc. Dirt or conden-
sation on the lens inside this unit may also
prevent playback.
• Titles and other text information recorded on a
CD-R disc may not be displayed by this unit.
• This unit conforms to the track skip function
of the CD-R disc. The tracks containing the
track skip information are skipped automati-
cally.
• Read the precautions with CD-R discs before
using them.
Understanding built-in CD player
error messages
When problems occur during CD play an error
message may appear on the display. If an error
message appears on the display refer to the
table below to see what the problem is and the
suggested method of correcting the problem. If
the error cannot be corrected, contact your
dealer or your nearest Pioneer Service Center.