Pioneer FH-P4000R - Manual (Page 45)

Digital Signal Processor
En 45
10
Section
English
Español
Deutsch
F
rançais
Italiano
Nederlands
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
FLAT , can be adjusted to a fine
degree (nuance control).
1 Press DSP to select the graphic equalizer.
Press DSP until PWFL appears in the display.
• If the graphic equalizer has been previously
set to an equalizer curve other than
PWFL then
the title of that previously selected equalizer
curve will be displayed, such as
S-BASS , NTRL ,
VOCAL , CUSTOM , or FLAT .
2 Select a equalizer curve by pressing 1–6 .
3 Press
5 or ∞ to adjust the equalizer curve.
Each press of
5 or ∞ increases or decreases
the equalizer curve respectively.
•
+6 – –5 (o r –6 ) is displayed as the equalizer
curve is increased or decreased.
• The actual range of the adjustments are differ-
ent depending on which equalizer curve is
selected.
Note
• You can store the adjusted equalizer curve in
CUSTOM by pressing and holding button 5
until MEMORY appears in the display.
Adjusting 9-band graphic equalizer
For CUSTOM equalizer curve, you can adjust
the level of each band.
1 Recall CUSTOM equalizer curve.
See Recalling equalizer curves on the previous
page.
2 Press DSP to select 9-band graphic equal-
izer.
9-band graphic equalizer can only be selected
when you have selected
CUSTOM equalizer
curve. Press DSP until 50Hz appears in the dis-
play.
• If 9-band graphic equalizer has been previ-
ously adjusted, the frequency of that previously
selected will be displayed instead of
50Hz .
3 Press
2 or 3 to select the equalizer band
to adjust.
Each press of
2 or 3 selects equalizer bands in
the following order:
50 — 100 — 200 — 400 — 800 — 1.6 k — 3.2 k — 6.3 k —
12.5 k (Hz).
Press
2 or 3 until the desired equalizer band
appears in the display.
4 Press
5 or ∞ to adjust the level of the
equalizer band.
Each press of
5 or ∞ increases or decreases
the level of the equalization band.
•
+6 – –6 is displayed as the level is increased or
decreased.
• You can then select another band and adjust
the level.
Notes
• You can create different CUSTOM curves for
different sources.
• The built-in CD player and the multi-CD player
are set to the same equalizer adjustment
setting automatically.