Pioneer PDP-507XD - Manual (Page 19)

19
En
Preparation 05
English
Attaching speed clamps to the main unit
Attach the speed clamps using the 3 holes (42 inches: 2 holes)
marked with below, depending on your routing system.
for PDP-507XD
for PDP-427XD
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the Plasma
Television and snap [2] into the back of [1] to lock the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
Be careful not to subject any connecting cables to strain.
NOTE
• Use the supplied speed clamps as necessary.
Connecting to an antenna
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used
for a coaxial cable.
Antenna cable (commercially available)
3 4
OUT
IN
3 4
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• For viewing both analogue and digital broadcasts, connect the
antenna cable to the ANT OUT terminal (antenna through out) and
ANT (analogue input) terminal.
• If “Aerial Power” setting is enabled, use an indoor antenna with signal
amplifier, 5V 30mA.
• For viewing analogue broadcasts only, connect
the 75-ohm coaxial cable (commercially
available) to ANT (analogue input) terminal.
If your outdoor antenna uses a 75-ohm coaxial cable with a standard
DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear of
the Plasma Television.
PDP507XDE.book Page 19 Friday, June 2, 2006 3:07 PM