Pioneer PDP 434HDE - Manual (Page 50)

10 Enjoying through External Equipment
50
En
SERVICE ONLY
i / o link.A
SELECT
CONTROL
SUB WOOFER
OUTPUT
INPUT 3
COMPONENT
S- VIDEO VIDEO R-AUDIO-L
MONITOR
OUTPUT
Y P B P R
VIDEO
I N OUT
INPUT 1
INPUT 2 INPUT 3
AC INLET
BLACK
WHITE
SYSTEM CABLE
INPUT
2 3
INPUT 1
INPUT 2 INPUT 3
Watching a DVD image
Connecting a DVD player
Use the INPUT 3 terminal when connecting to a DVD
player and other audiovisual equipment.
• If a SCART cable has been connected to the INPUT 3
terminal with the i/o Link.A activated, input signals
(other than Component) are automatically identified
and displayed. If the i/o Link.A has been deactivated,
Video is always selected for signals other than RGB
because the system cannot identify among RGB, Y/C
(S-Video), and CVBS (Video) signals; for example,
receiving Y/C (S-Video) signals results in mono-
chrome display.
DVD player
Media Receiver (rear view)
SCART cable
(commercially available)
When using component cable,
select “COMPONENT” for “Input
Select” in the menu. See page 65.
At the same time connect a SCART
cable to input audio signals.
Displaying a DVD image
To watch a DVD image, press INPUT 3 on the remote
control unit or press INPUT on the Plasma Display to
select INPUT3.
Component cable
(commercially available)
• If DVD images do not come in clearly, you may need
to change the input signal type setting using the
menu. See pages 65 and 66.
• Refer to your DVD player operation manual for the
signal type.