Pioneer AVIC-HD1BT - Manual (Page 174)

172
Appe
n
d
ix
NA
V
I/
A
V
Messages and How to React to Them
Messages for navigation functions
The following messages may be displayed by your navigation system.
❒ There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Dialing is not possible because the
touch keys for dialing is inactive.
Your phone is out of range for serv-
ice.
Retry after entering within range for
service.
The connection between mobile
phone and the Bluetooth unit (navi-
gation system) cannot be established
now.
Perform the connection process.
The mobile phone is not registered to
the navigation syetem yet.
To use the mobile phone featuring
the Bluetooth wireless technology
with this navigation system, the reg-
istration process is necessary.
Symptom Cause Action (See)
Message When What to do
Irregular speed pulse signal
detected. Please power off the sys-
tem and check the installation. Then,
please re-boot the system and press
“OK”.
If the navigation system does not
receive the vehicle speed pulse.
Consult your Pioneer dealer.
Speed pulse not connected. Calibra-
tion will start without speed pulse.
Accuracy is not fully ensured without
speed pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Vibration detected. Please power off
the system and check the installa-
tion. Then, please re-boot the system
and press “OK”.
The navigation unit is installed in a
place where it may be affected by a
large vibration.
Re-install the navigation unit in a
place where the unit will not be
affected by vibration.
Direction of G sensor is not correct.
Please power off the system and
check the installation. Then, please
re-boot the system and press “OK”.
Direction of G sensor is set incor-
rectly.
See the Installation Manual and set
the direction of the navigation unit
correctly.
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service centre.
Abnormal output of Gyrosensor is
detected.
Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
Positioning is not possible due to the
hardware. Please contact your dealer
or Pioneer service centre.
The location display is not possible
due to failure of hardware.
Consult your dealer.
GPS antenna problem detected.
Please contact your dealer or Pioneer
service centre.
The location display is not possible
due to failure of GPS aerial.
Consult your dealer.
This function is currently unavailable. The screen cannot be displayed with
Vehicle Dynamics Display.
Because the sensor has not been
taught so the sensor information
cannot be acquired.
If the sensor learning status reaches
the Sensor Initialising status or
more, the system is ready to be used.
MAN-HD1BT-SOFTW-EN.book Page 172 Thursday, April 20, 2006 3:47 PM