Pioneer AVIC-HD1BT - Manual (Page 141)

139
AV
Ch
ap
te
r
14
Cu
st
om
isin
g t
h
e A
u
d
io
S
et
tin
g re
la
te
d
wi
th
A
u
d
io
V
is
u
al
1
Touch [Rear SP] in the System Settings
menu.
2
Touch [Full] or [Sub.W] to switch the rear
output setting.
❒
When no subwoofer is connected to the
rear output, select Full. When a subwoofer
is connected to the rear speaker leads
directly, select Sub.W.
3
Touch [Preout] to switch the subwoofer
output or non fading output.
❒
When the [Rear SP] setting is Sub.W,
[Preout] is invalid.
❒ Even if you change this setting, there is no
output unless you turn [Non Fading] or
[Sub Woofer] in the Audio Settings
menu [On].
➲ “Using non fading output” ➞ Page 132
➲ “Using subwoofer output” ➞ Page 132
Switching Auto PI seek
The navigation system can automatically search
for a different station with the same program-
ming, even during preset recall.
❒ This function is intended for FM as audio
source. There is no effect on RDS-TMC func-
tionality.
❒ [Auto PI] can be set only when the source is
[OFF].
1
Touch [Auto PI] in the System Settings
menu.
Touching [Auto PI] switches between [On]
and [Off].
Setting the FM tuning step
Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA is on, the tun-
ing step automatically changes to 100 kHz. It may
be preferable to set the tuning step to 50 kHz
when AF is on.
❒ [FM Step] can be set only when the source is
[OFF].
1
Touch [FM Step] in the System Settings
menu.
Each time you touch [FM Step] will switch
the FM tuning step between 50 kHz and 100
kHz while AF or TA is on.
❒
The tuning step remains at 50 kHz during
manual tuning.
Selecting the TV signal
This setting is required when a Pioneer TV tuner
is connected using the AV-BUS. (This setting is
not necessary otherwise.) If the image cannot be
displayed correctly using [Auto], switch the set-
ting to the TV system (Colour system) that your TV
can receive, or to the TV system (Colour system)
currently being received.
❒ [TV SIG] can be set only when the source is
[OFF].
1
Touch [TV SIG] in the System Settings.
Each touch of [TV SIG] changes the settings
as follows:
• Auto – Select this setting when you watch
the channel both PAL and SECAM system.
• PAL – Select this setting when you watch
the channel in PAL system only.
• SECAM – Select this setting when you
watch the channel in SECAM system only.
❒ TV tuner has no compatibility for selected
TV system (Colour system), video image is
not output correctly even though you set
the appropriate setting. For the details of
compatibility for TV system (Colour sys-
tem), refer to the “Owner’s Manual” of the
TV tuner.
Other Functions
Selecting the video for “Rear
display”
You can choose either to show the same image
as the front screen or to show the selected
source on the “Rear display”.
MAN-HD1BT-SOFTW-EN.book Page 139 Thursday, April 20, 2006 3:47 PM