Blaupunkt RDM 127 User Manual
Page 61
CD - Betrieb (Option)
61
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
•
Press << / >> to select the frequency band you wish to correct, e.g. 1 kHz.
The selected frequency band will appear in the bottom line.
•
Press / to adjust the frequency range as desired.
After completing the adjustments, press
NEXT
and adjust the loudspeaker on
the front right, rear left and rear right.
If necessary, adjust the other channels as described above.
•
Press
EXIT
to exit the menu.
Die letzte Einstellung ist automatisch gespeichert.
Note:
During the calibration procedure, loudspeakers should be hooked up to all four
connections.
If one of the loudspeakers is not detected during calibration because it is defec-
tive, not connected or obstructed, then a linear equalizer control will be done for
this loudspeaker pair.
The balance/fader settings can be adjusted in a limited range only.
Calling up the Hi-fi calibration
If you want the playback to function according to the Hi-fi calibration,
•
press S,
EQ
and the corresponding softkey (AUTO-EQ1 ... AUTO-EQ3)
one after the other.
S
------------------
NEXT
SET AUTO-EQ 2
FRONT LEFT
EXIT
1
k HZ
BA NewYork gb®
24.05.2002, 11:59 Uhr
61