Blaupunkt RDM 127 - Manual (Page 35)

CD - Betrieb (Option)
35
DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS
Checking TIM times:
The TIM time of the timer marked by a highlighter bar will appear in the display
header.
If you want to see the time set for the other timer,
•
press the corresponding key or .
Setting TIM times:
You can set the TIM times for TIMER 1 and TIMER 2 in the TIM menu. The
timer which you can programme will be highlighted. TIMER will appear in the
display header along with the preset time.
•
Select TIMER 1 or TIMER 2 .
• Alter the hours by pressing - HOURS / HOURS + and the minutes
by pressing - MIN / MIN + .
Alter the other TIM time if necessary. After completing the settings, exit the TIM
menu by
•
pressing EXIT .
Recalling stored traffic messages
• Press TIM briefly or press SRC on the remote control for approximately
1 second.
The display will indicate the recorded traffic messages T1 to T4 with each of the
corresponding recording times.
The messages will be played back automatically, starting with T4, T3, T2 and T1,
depending on how many messages have been recorded. If no messages have
been recorded,
NO TIM MESSAGE will appear in the display panel.
Calling up specific messages:
You can call up any of the individual messages by
•
pressing the corresponding key .
S
TIMER 1
- HOURS
- MIN
EXIT
TIMER 1
HOURS +
MIN +
07:00
ACTIVE
TIMER 2
S
TIM NDR 2
T4 08:27
T3 08:00
EXIT
T2 07:27
T1 07:01
CUE
REVIEW
BA NewYork gb® 24.05.2002, 11:58 Uhr 35