Olympus PT-038 - Manual (Page 71)

EN 33
EN
8. Appendix
Q & A on the use of the PT-038
Q1: What digital camera models can be used with this product?
A1: This product (PT-038) is designed exclusively for use with the
FE-230/X-790 digital camera.
Q2: What cautions must be observed when loading the digital
camera into the Case?
A2: Pay special attention to the following items when loading the
camera into the Case.
1
Make sure that the digital camera has enough battery power left.
Battery power is used up very quickly underwater due to frequent
flash use.
2 Check the remaining number of pictures on the image storage.
Please use a card with a sufficient remaining number in order to
reduce the number of times the Case has to be opened and closed.
3 Remove the strap from the digital camera. When the camera is
loaded without removing the strap, the strap may get caught when
the Case is sealed and this will cause water leakage.
4 Turn off the camera.
5 Before sealing the Case, confirm that the O-ring has been installed
properly in the groove on the rear lid of the Case.
6 Confirm that the O-ring and the O-ring contact surface on the front
lid are free of dirt, hairs and other foreign matter.
7 Insert the silica gel for defogging. Please use silica gel for the
Olympus Case.
Q3: What cautions must be observed when using and storing the
Case?
A3: Pay special attention to the following items.
1
When the O-ring contact surface is pressed strongly from the
outside of the Case, or when the Case is twisted, the waterproof
function may be impaired and water leakage may occur.
PT038_EN.book Page 33 Tuesday, December 26, 2006 12:54 PM