Olympus PT-038 - Manual (Page 52)

EN 14
EN
Setting the Zoom Lever
When loading the digital camera in the Case, fit the projecting part of the
zoom lever of the digital camera into the recessed part of the zoom lever
on the inside of the Case.
CAUTION:
When loading the camera, confirm that the projecting part of the zoom lever of
the camera is properly set to the recessed part of the zoom lever of the Case.
When the setting is insufficient, the loading of the camera becomes imperfect
and it may not be possible to seal the Case or zooming may not function.
Insufficient sealing will cause water leakage.
How to Use the POWER Button
Press the POWER button to turn the
camera ON/OFF.
CAUTION:
To save battery power, the camera automatically goes into sleep mode and
the monitor turns off if there is no operation when the camera is turned on. No
picture is taken even if the shutter button is fully pressed in this mode. Operate
the zoom lever or other buttons to restore the camera from sleep mode before
taking a picture. If the camera is left for 12 minutes, it automatically turns off.
Press POWER button to turn the camera on.
For details, refer to your digital camera’s instruction manual.
POWER button
PT038_EN.book Page 14 Tuesday, December 26, 2006 12:54 PM