79 en – Olympus Tough TG-1 iHS User Manual
Page 79
79
EN
• If a battery leaks fl uid onto your clothing or skin, remove the
clothing and fl ush the affected area with clean, running cold water
immediately. If the fl uid burns your skin, seek medical attention
immediately.
• Never subject batteries to strong shocks or continuous vibration.
CAUTION
• Before loading, always inspect the battery carefully for leaks,
discoloration, warping, or any other abnormality.
• The battery may become hot during prolonged use. To avoid minor
burns, do not remove it immediately after using the camera.
• Always unload the battery from the camera before storing the camera
for a long period.
• This camera uses one Olympus lithium ion battery
(LI-90B). No other type of batteries can be used.
There is a risk of explosion if the battery is replaced with the incorrect
battery type.
• Power consumption by the camera varies depending on which
functions are used.
• During the conditions described below, power is consumed
continuously and the battery becomes exhausted quickly.
• The zoom is used repeatedly.
• The shutter button is pressed halfway repeatedly in shooting mode,
activating the auto focus.
• A picture is displayed on the screen for an extended period of time.
• The camera is connected to a printer.
• Using an exhausted battery may cause the camera to turn off without
displaying the battery level warning.
• The Olympus lithium ion battery is designed to be used only for the
Olympus digital camera. Do not use the battery to other devices.
• If the battery’s terminals get wet or greasy, camera contact failure
may result. Wipe the battery well with a dry cloth before use.
• Always charge a battery when using it for the fi rst time, or if it has not
been used for a long period.
• When operating the camera with battery power at low temperatures,
try to keep the camera and spare battery as warm as possible. A
battery that has run down at low temperatures may be restored after it
is warmed at room temperature.
• Before going on a long trip, and especially before traveling abroad,
purchase extra batteries. A recommended battery may be diffi cult to
obtain while traveling.
• When storing the battery for a long period, select a cool location
for storage.
• Please recycle batteries to help save our planet’s resources. When
you throw away dead batteries, be sure to cover their terminals and
always observe local laws and regulations.
USB-AC adapter
USB-AC adapter
• The included USB-AC adapter F-2AC is designed to be used only
with this camera. Other cameras cannot be charged with this USB-AC
adapter.
• Do not connect the included USB-AC adapter F-2AC to equipment
other than this camera.
• For plug-in type USB-AC adapter:
The included USB-AC adapter F-2AC is intended to be correctly
orientated in a vertical or fl oor mount position.
Use Only Dedicated Rechargeable Battery,
Use Only Dedicated Rechargeable Battery,
Battery Charger and USB-AC adapter
Battery Charger and USB-AC adapter
We strongly recommend that you use only the genuine Olympus
dedicated rechargeable battery, battery charger and USB-AC adapter
with this camera. Using a non-genuine rechargeable battery, battery
charger and/or USB-AC adapter may result in fi re or personal injury
due to leakage, heating, ignition or damage to the battery. Olympus
does not assume any liability for accidents or damage that may result
from the use of a battery, battery charger and/or USB-AC adapter that
are not genuine Olympus accessories.
Monitor
Monitor
• Do not push the monitor forcibly; otherwise the image may become
vague, resulting in a playback mode failure or damage to the monitor.
• A strip of light may appear on the top/bottom of the monitor, but this
is not a malfunction.
• When a subject is viewed diagonally in the camera, the edges may
appear zigzagged on the monitor. This is not a malfunction; it will be
less noticeable in playback mode.
• Static images displayed on organic EL monitors for extended periods
of time may “burn in”, causing a drop in brightness or discoloration in
some areas of the display, which may be permanent in some cases.
This phenomenon has no effect on images recorded with the camera.
• The monitor of this product is manufactured with high-quality
accuracy, however, there may be a stuck or dead pixel on the monitor.
These pixels do not have any infl uence on the image to be saved.
Because of the characteristics, the unevenness of the color or
brightness may also be found depending on the angle, but this is due
to the structure of the monitor. This is not a malfunction.