Olympus DM-2 - Manual (Page 81)

1
3
EN
M
en
u s
et
tin
g m
et
ho
d
Menu setting method
Characters
You can change the setting of the display
character to match the character code of the
text file stored in the [TEXT] folder. In order to
have the recorder read out the text file created
in diverse environments, change the character
code if necessary.
1 From the [Home] menu display
select [Audiobooks], and then
press the `OK or 9 button.
2 In the Book list display, press the
F (MENU) button.
Text Language
You can change the language for reading
out the text files stored in the [TEXT] folder.
1 From the [Home] menu display
select [Audiobooks], and then
press the `OK or 9 button.
2 In the Book list display, press the
F (MENU) button.
3 Press the + or − button to select
[Book Menu], and then press the
`
OK or 9 button.
4 Press the + or − button to select
[Text Language], and then press
the `OK or 9 button.
5 Set the Language.
[English] [Français] [Español]:
Notes
• When the [LCD/Sound Menu] – [Voice
Guide] setting (☞ P.87) is set to [On], the
[Text L anguage] setting cannot be changed.
Set the [Voice G uide] setting to [Off], and
then specify the [Te xt Language] setting.
• When the [Voice Guide] setting (☞ P.87)
is [On], the language for reading out text
files will be the same as that set for the
voice guidance in [T ext Language].
Skip mode list:
[Section]
(Level1~6)
Denotes chapters, sec-
tions, paragraphs, etc. in
DAISY contents.
Example: [Level 1] is equiv-
alent to chapters, [Level 2]
is equivalent to sections,
and [Level 3] is equivalent
to paragraphs.
[Group]
A portion within a section is
called a group. Groups are
sometimes set for the be-
ginning and end of diagram
explanations.
[Page]
Equivalent to the page
of book.
[Phrase]
When reading a text aloud,
a breathing interval is
created at the punctuation
between sentences. The
audio between this inter-
val and the next interval is
called a “phrase”.
[Bookmark]
Indicates a location where
an index mark (bookmark)
is set.
Note
• Depending on the DAISY contents, there
are cases where there is no location
corresponding to a dividing interval.
3 Press the + or − button to select
[Book Menu], and then press the
`
OK or 9 button.
4 Press the + or − button to select
[Characters], and then press the
`
OK or 9 button.
5 Select the [ANSI], [UTF-] or [UTF-
1 ].