Olympus DM-2 - Manual (Page 22)

1
EN
Power supply
1 While pushing down on the
grooves using both thumbs, slide
the battery cover in the direction
indicated by the arrow.
Inserting the battery
This recorder uses a lithium ion battery
specified by Olympus (LI-50B). Do not use
any other type of battery.
2 With the back label of the battery
facing up, line up the terminals of
the recorder and battery. Insert the
battery by sliding in direction A
while pushing down in direction B.
3 Close the battery cover by sliding
all the way in direction B while
pushing down in direction A.
• Be careful of the direction of the
battery when inserting it.
• The supplied rechargeable battery
is not fully charged. Before using the
unit the first time or after long periods
of disuse, it is recommended that you
charge it until full (☞ P.23).
Notes
• Be sure to stop the recorder before replacing
the battery. Unloading the battery while the
recorder is in use may corrupt the file.
• The battery cover is not attached at the
time of purchase.
• Do not use too much force when inserting
the battery. Use only the method listed
above to install and remove the battery.
Otherwise, damage may occur.
• If it takes longer than 15 minute to replace
the dead battery or if you take the battery
in and out repeatedly at short intervals, you
may have to reset the time when you have
loaded fresh batteries (☞ P.29).
• Remove the battery if you are not going to
use the recorder for an extended period of
time.
Po
w
er s
up
ply