Brother NX-200 - Manual (Page 21)

Winding/Installing the Bobbin 15
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
c
Slide the sewing speed controller to the right
(so that the speed will be fast).
1 Sewing speed controller
d
Press (start/stop button) once.
1 Start/stop button
X The bobbin starts spinning and the thread is
wound around the bobbin.
X The bobbin stops spinning when it is full.
e
Press (start/stop button) once.
X The sewing machine stops.
f
Use scissors to cut the end of the thread
wound around the bobbin.
g
Slide the bobbin winder shaft to the left.
h
Remove the bobbin from the shaft.
i
Slide the sewing speed controller back to its
original position.
Memo
● When the sewing machine is started or the
balance wheel is turned after winding the
thread around the bobbin, the machine will
make a clicking sound; this is not a
malfunction.
● Be sure to cut the thread as described on
the previous page. If the bobbin is wound
without cutting the thread using the
cutter built into the slit in the bobbin
winder seat, the thread may become
tangled in the bobbin or the needle may
bend or break when the bobbin thread
starts to run out.
CAUTION
1
1
● Use a bobbin thread that has been
correctly wound, otherwise the needle
may break or the thread tension will be
incorrect.
CAUTION
F0_brotherE.book Page 15 Wednesday, May 21, 2003 11:38 AM