Brother NX-200 - Manual (Page 19)

Winding/Installing the Bobbin 13
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
1
Turn on the sewing machine.
2
Lift open the upper cover.
3
Place the bobbin on the bobbin winder shaft
so that the spring on the shaft fits into the
notch in the bobbin.
1 Notch
2 Bobbin winder shaft spring
4
Slide the bobbin winder shaft to the right.
5
Remove the spool cap that is inserted onto the
spool pin.
1 Spool pin
2 Spool cap
6
Place the spool of thread for the bobbin onto
the spool pin.
Slide the spool onto the pin so that the spool is
horizontal and the thread unrolls from the
bottom front of the spool.
• If the spool is not positioned so that the
thread unrolls correctly, the thread may
become tangled around the spool pin.
7
Slide the spool cap onto the spool pin.
With the rounded side of the spool cap
positioned toward the left, slide the spool cap
onto the spool pin as far as possible until the
right side of the spool touches the right end of
the spool pin.
• Three spool cap sizes are available (large,
medium and small). Use the spool cap with
a diameter that is slightly larger than the
diameter of the spool. The medium-sized
spool cap is already on the spool pin when
the sewing machine is purchased.
1 Spool cap (large)
2 Spool cap (medium)
3 Spool
• When using a spool of cross-wound thread,
install the small spool cap with some space
between the cap and the spool.
1 Spool
2 Gap
3 Spool cap (small)
1
2
1
2
1 2
3
1
2
3
F0_brotherE.book Page 13 Wednesday, May 21, 2003 11:38 AM