AEG 49332I-MN - Manual (Page 8)

To bake and roast or as a pan to col-
lect fat.
• Roasting pan grid
To put in the deep roasting pan.
4. BEFORE FIRST USE
WARNING!
Refer to the Safety chapters.
4.1 Initial Cleaning
• Remove all accessories and removable
shelf supports (if applicable).
• Clean the appliance before first use.
Refer to the chapter "Care and
cleaning".
4.2 Sensor field
Touch and hold for minimum 1
second the sensor field on the
control panel to operate the ap-
pliance.
1s
4.3 Setting the time
You must set the time before you
operate the oven.
When you connect the appliance to the
electrical supply or after a power cut, the
indicator for the Time function flashes.
Press the + or - button to set the correct
time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
You can only change the time
if :
• The child safety device is not
on.
• None of the clock functions
Duration or End is set.
• No oven function is set.
4.4 Preheating
Preheat the empty appliance to burn off
the remaining grease.
1.
Set the function and the maxi-
mum temperature.
2. Let the appliance operate for one
hour.
3. Set the function and the maxi-
mum temperature.
4. Let the appliance operate for ten mi-
nutes.
5.
Set the function and the maxi-
mum temperature.
6. Let the appliance operate for ten mi-
nutes.
Accessories can become hotter than
usually. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
8 www.aeg.com