AEG 49332I-MN - Manual (Page 11)

2. Set the heat setting for the cooking
zone. You can also set it after you
activate the timer.
3. To activate the timer or change the
set time, touch + or - on the hob
control panel. The maximum time
you can set is 99 minutes.
The indicator of the cooking zone
flashes slowly. The timer starts to
count down.
4.
To see the remaining time, touch
again and again until the indicator
for the necessary cooking zone flash-
es quickly. The display shows the re-
maining time.
When the set time ends, 00 flashes
and an acoustic signal sounds. The
cooking zone deactivates.
5. Touch to stop the signal.
To deactivate the timer before
the set time is completed, set the
cooking zone with
and touch
-. The remaining time counts
down to 00. The indicator of the
cooking zone goes out.
You can use the timer as a Minute Mind-
er when the cooking zones do not oper-
ate. To do this, set the cooking zone and
activate the timer but do not set the
heat setting.
5.9 Stop and Go
The Stop and Go function sets all
cooking zones that operate to the lowest
heat setting (
).
This function does not deactivate the
timer function.
• To activate this function, touch
.
The display shows the symbol .
• To deactivate this function, touch .
The display shows the heat setting
that you set before.
When the Stop and Go function
operates, you cannot change the
heat settings.
5.10 Lock
When the cooking zones operate, you
can lock the control panel but not
. It
prevents an accidental change of the
heat setting.
This function does not deactivate the
timer function.
1. Set the heat setting.
2.
To activate this function, touch .
The display shows the symbol for
4 seconds.
3. To deactivate this function, touch
. The display shows the heat setting
that you set before.
When you deactivate the appli-
ance, the function is deactivated.
When you activate the appliance, the
display shows SAFE .
The lock function locks or un-
locks the oven interface at the
same time.
5.11 Residual heat indicator
The residual heat indicator comes on
when a cooking zone is hot.
WARNING!
There is a risk of burns from re-
sidual heat.
5.12 Child safety device
This function prevents an accidental op-
eration of the hob.
Activating the child safety device
1. Touch to activate the hob. Do
not set the heat settings.
2. Touch for 4 seconds. The display
shows the symbol . The child
safety device operates.
3.
Touch to deactivate the hob.
Deactivating the child safety device
1.
Touch to activate the hob. Do
not set the heat settings.
2.
Touch for 4 seconds. The display
shows the symbol .
3.
Touch to deactivate the hob.
Overriding the child safety device for
one cooking session
1. Touch to activate the hob. The
display shows the symbol .
ENGLISH
11