AEG Rear Camera System RV 3.5 - Manual (Page 18)

2.2.6 Only install the backup camera system in a
safe environment! Keep clothing, hair, limbs and
the backup camera system away from moving
and hot engine- and car parts!
2.2.3 Always follow safety instructions if the
vehicle is on jacks or a car lift or the like!
2.2.2 Do not run or start the vehicle while
installing the backup camera system!
2.2.1 Before installing the backup camera system
and before each functionality test of the
backup camera system, secure the vehicle to
prevent it from rolling away. Attention – risk of
injury and property damage! Always en-
gage the hand brake and shift into gear!
Automatic transmissions must be put into
Park and the hand brake engaged!
2.2 Safety instructions for backup
camera installation
2.1.23 After using a car wash, the camera‘s
detection range may change due to mechanical
effects. Be sure to check for this and readjust the
camera if necessary.
2.1.22 Bright light hitting the camera lens
directly may result in objects being overexposed
and not being displayed clearly.
2.1.21 Extreme high or low temperatures or ra-
pid temperature changes may cause the camera
to not function properly or cause the monitor to
not show objects correctly.
2.1.20 The backup camera system may interfere
with other cordless equipment (e.g. mobile pho-
nes, Bluetooth equipment) during use or receive
interference. Thus, do not use such equipment
near the backup camera system or this system
near other wireless equipment.
2.1.19 Be sure all plugs and power cables are
dry. Never power on the equipment with moist or
wet hands!
2.1.18 The camera is protected against rain but
not waterproof! Do not immerse camera in water
or other liquids!
2.1.17 Never allow liquids to enter the monitor!
Never immerse the monitor in liquids! Only
operate the monitor dry.
2.1.16 Powering the backup camera system
requires an input voltage of 12 V / DC. Always
disconnect the monitor from the power source by
unplugging the 12 V plug when not in use. Never
pull on the connector cable to disconnect!
2.1.15 Do not use the cable to carry or pull on
the camera or transmitter.
2.1.14 Be sure there is ample clearance around
the monitor and transmitter to ensure adequate air
circulation during use. Do not cover the monitor
or transmitter with objects!
2.1.13 Do not use other cables or accessories.
Do not extend the cables.
2.1.12 Do not operate the backup camera system
after it has been dropped or otherwise damaged.
Take to a qualified electrician for inspection or
repair!
2.1.11 The backup camera system may not be
modified (altered).
2.1.10 All repairs to the backup camera system
must be performed by a qualified electrician /
qualified specialist.
2.2.4 Caution! Risk of electrical
voltage near the spark coils, distributor
cap, ignition cables, spark plugs and
electrical components inside the vehicle!
2.2.5 Follow the automaker‘s safety instructions
and manual!
18
97152_R ckfahrkamera_RV3.5_ Manual _07_03_12_Print
Mittwoch, 7. M rz 2012 11:42:16