AEG Voxtel S120 - Manual (Page 34)

34
tPress
OK
and / to select “RCID“.
tPress
OK
and / to select “NUM LEN“.
tPress
/ to select among 5, 6 and 7.
tPress
OK
to confirm.
10.6.7.3 Set the ring delay
tPress and
/ to select “BS SET“.
tPress
OK
and / to select “RCID“.
tPress
OK
and / to select “RINGS“.
tPress
/ to select among “0 RING“, 2“ RINGS“, “3 RINGS“, to “9
RINGS“, nine options are available in total.
Note:
If 0 RING is selected, the manual mode will be enabled.
10.6.8 Set the PBX access code (Optional)
tPress and
/ to select “BS SET“.
tPress
OK
and / to select “PBX CODE.“
tPress
OK
and then enter the PBX access code. Only one digit can be
entered.
tPress
OK
to confirm.
10.6.9 Set the area code (Optional)
tPress and
/ to select “BS SET“.
tPress
OK
and / to select “AREA COD“.
tPress
OK
and then enter the area code. Only three digits in maximum
can be entered.
tPress
OK
to confirm.
10.6.10 Set the carrier code (Optional)
tPress and
/ to select “BS SET“.
tPress
OK
and / to select “CARR COD“.
tPress
OK
and then enter the carrier code. Only three digits in maximum
can be entered.
tPress
OK
to confirm.
10.7 Registration
Your handset and base station is pre-registered. Up to five handsets can
be registered to a single base station.