AEG Voxtel S120 - Manual (Page 24)

24
An alarm tone will be emitted from the earpiece to notify user the
alarm time is reached. Once user press any key or press and hold to
disable the alarm, it will revert to the call duration screen.
>During paging or ringing, the alarm will not sound when the alarm
time is reached. However, if snooze function is enabled, the alarm
will sound again at the end of the snooze period provided that it’s not
ringing or in paging mode at the end of the snooze period.
10.2.1 Turn on/off the alarm
tPress and
/ to select “ALARM“.
tPress
OK
and / to select “ON/OFF“.
tPress
OK
to confirm.
Note:
If “ON“ is selected, you will be asked to set the alarm time.
10.2.2 Set the alarm time (if the alarm is set to be “ON“)
tFollow Steps 1 to 4 in Section 11.2.1.
tEnter the alarm time.
tPress
OK
to set the snooze function.
tPress
OK
and / to select “ON“ or “OFF“.
tPress
OK
to confirm.
10.3 Set the direct memory keys
There are four direct access memory buttons (from M1 to M4) on the
corded base and three direct access memory buttons (M1 to M3) on the
handset.The memory numbers on base and handset are linked, M1 to M3
share same number on handset and base. M4 can only be dialled from
the base.
tPress and
/ to select “MEM KEY”.
tPress
OK
and / to select the desired memory key.
tPress
OK
to enter the number you want to store.
Note:
If a number has been saved into the selected memory key before, the last
saved settings will be shown. You can use the dial keys to edit the number.
tPress
OK
to confirm.