AEG Voxtel D235 - Manual (Page 29)

29
UK
You can register additional handsets to have up to five handsets per base
unit, with each handset‘s number (1 to 5) shown on its display. (Note: each
handset can only be registered to one base.)
10.6 To register a new handset to your base:
tPress and hold on the base station for more than five seconds, to
put the base station into registration mode. It will stay in registration
mode for about 1 minute, so the following handset sequence must be
completed within this time.
tPress and
/ to select “REGISTRATION”.
tPress
OK
to display “PIN?------”.
tEnter the 4-digit system pin (default “0000”).
tPress
OK
to confirm, and the display will show “PLEASE WAIT”.
If the handset registration is successful, you will hear a confirmation tone
and the will stop flashing.
The handset will automatically be allocated the next available handset
number. This handset number is shown in the handset display in standby
mode. If the handset registration is unsuccessful, the will still flash.
10.7 To register an additional wireless headset
Important:
The wireless headset is pre-registered when supplied and should not
need to be registered. Headset registration is only necessary when you
buy a new headset or if it has lost its registration, and the headset LED
is purple.
Note:
Before trying to register a headset to the base station, make sure the base
station system pin code is set to “0000”, otherwise you will not be able to
register the headset.
tPress and hold volume up key
18
together with volume down key
19
to put the headset into registration mode. The LED on the wireless
headset will toggle between red and blue.
tPress and hold on the base station for more than five seconds, to put
the base station into registration mode.
tPlace the unregistered wireless headset on the base charging bay.
tThe headset LED will flash blue for about 3 seconds and a long beep
tone is generated if the registration is successful.