AEG Voxtel D235 - Manual (Page 16)

16
tPress to dial to the selected redial number.
Note:
If there are no numbers in the redial list, the display shows “EMPTY”.
7.9.2 Store a redial number into the phonebook
tFollow Steps 1 and 2 in section 7.9.1.
tPress and
/ to select ”ADD TO PB”.
tPress
OK and then enter the name you want to use in the phonebook.
tPress
OK
and then modify the number, if necessary.
tPress
OK
to show “MELODY 1“.
tPress
/ to browse the ringtone list. The respective ringtone will be
played when browsing the ringtone list.
Note
The selected melody will only be played when you receive a call if you
subscribe to Caller Display and the incoming number matches the stored
number.
tPress
OK
to confirm, and the entry will be stored.
7.9.3 Delete a redial number
tFollow Steps 1 and 2 in section 7.9.1.
tPress and
/ to select “DELETE“.
tPress
OK to confirm, and the entry will be deleted.
7.9.4 Delete all redial list entries
tFollow Steps 1 and 2 in section 7.9.1.
tPress and
/ to select “DELETE ALL“.
tPress
OK
to display “CONFIRM?“.
tPress
OK
to confirm. All entries will be deleted and the display will show
“EMPTY“.
7.10 Find the handset
You can locate the handset by pressing the Find button in the middle
of the front of the base station. All the handsets registered to the base
will produce the paging tone and show “PAGING“ on the display for 60
seconds.
You can stop the paging by pressing / / on any handset or on
the base again.