AEG Solo combo 15 - Manual (Page 28)

26
tPress to select the handset number to un-register and then press to confirm or press
to cancel the un-registration procedure.
>A confirmation tone is played to indicate successful un-registration.
15.4 Change the Master PIN from your Cordless Handset
The Master PIN is used for registration/un-registration of the cordless handsets and for accessing the
answering machine remotely. The default Master PIN number is 0000. The maximum length of the
Master PIN is 8 digits.
Note:
If you forget your PIN code, you can reset it to its default 0000 using a handset Reset.
tFrom the home screen, press .
tPress
to “ADVANCED SET” and then press to select.
tPress
to “CHANGE PIN” and then press to select.
tEnter the current Master PIN and then press to confirm.
>The PIN will be shown as asterisks (*) on the screen as you enter them.
tEnter the new PIN and then press to confirm.
>A confirmation tone is played.
15.5 Set the Auto Prefix on your Cordless Handset
You can set the phone to detect the start of a dialling number and replace it with another number.
You can enter up to 5 digits for the number to be detected, which can be replaced with an auto prefix
number of up to 10 digits.
tFrom the home screen, press
.
tPress to “ADVANCED SET” and then press to select.
tPress
to “AUTO PREFIX” and then press to select.
tPress again to enter “DETECT DIGIT”.
>The last stored detect number is displayed (if any).
tEnter the number you want to be detected (maximum 5 digits) and then press
to confirm.
>A confirmation tone is played.
tPress
to “PREFIX” and press to select.
>The last stored prefix number is displayed (if any).
tEnter the number you want the detected number to be replaced with (maximum 10 digits) and then
press to confirm.
>A confirmation tone is played.
tPress to return to standby mode.
Note:
If the detect digit is not entered (blank), the prefix number will be automatically added to the pre-dial
number after is pressed.
For numbers starting with *, # or P, the prefix number will not be added to the pre-dial number after
is pressed.