AEG Solo combo 15 - Manual (Page 11)

9
UK
Note:
You need to subscribe to Caller Line Identification service to be able to see the caller’s number or
name in the call log.
8.1.5 Call from the Phonebook
tPress key in standby mode.
tPress to select the desired entry in the phonebook and then press to dial out the selected
phonebook number.
8.2 Answer and End a Call
tWhen the phone rings, press .
tTo end a conversation, press .
Warning:
When the handset is ringing, please do not hold it too close to your ear as the volume of the ringing
tone may damage your hearing.
Note:
You can simply place the handset back on its base station or charger pod to end the call. Make sure
that you have not deactivated the Auto hang-up feature.
8.3 Handset Speakerphone
During a call, you can press to alternate between hands-free speakerphone and handset earpiece.
8.4 Adjust Earpiece Volume
There are 3 levels of earpiece volume.
tDuring a call, press
to select from “VOLUME 1” to “VOLUME 3”.
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
8.5 Adjust Speaker Volume
There are 5 levels of speaker volume.
tDuring a call, press
to select from “VOLUME 1” to “VOLUME 5”.
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
8.6 Mute/Unmute the Microphone
When the microphone is muted, the handset displays “MUTE ON”, and your caller cannot hear you.
tDuring a call, press
to turn on/off the microphone.
8.7 Paging
The paging feature enables you to locate a missing handset if the handset is in range and contains
charged batteries.
tPress under the base unit.
>All the registered handsets that are in range will start to ring.
You can stop the paging by pressing any key on the handset or the under the base unit again.